2.5A power-enhanced motor drive module with silicone wire, pin header, terminal. The power supply voltage is 2V~10V, which can drive two DC motors or one 4-wire 2-phase stepping motor at the same time. It can realize the function of forward and reverse and speed regulation, with thermal protection and automatic recovery.

1. Two-way H-bridge motor drive, can drive two DC motors or one 4-wire two-phase stepper motor at the same time;

2. Module supply voltage 2V-10V;

3. Signal input voltage is 1.8-7V;

4. Single working current 2.5A, low standby current (less than 0.1uA);

5. Built-in anti-common state conduction circuit, when the input terminal is suspended, the motor will not malfunction;

6. Built-in overheat protection circuit (TSD) with hysteresis effect, no need to worry about motor stall;

7. Product size: 31*32*5mm (length, width and height), small size, suitable for assembly and vehicle;

8. Mounting hole diameter: 2 mm.

9. Weight: 11g

INx connected to the MCU I / O port, MOTOR-A and MOTOR-B is connected to the motor.

DC motor drive logic truth table: