fbpx

DT3266L Clamp meter Digital AC DC Voltage

৳ 800.00

Available : 4 Sold : 1

4 in stock

SKU: 12816 Categories: ,

DT3266L clamp meter Portable LCD Digital Clamp Multimeter AC DC Voltage Electronic Tester Meter with Multimeter Pen (Battery not included)

DT3266L Clamp meter Digital AC DC Voltage
Special Features
3 1/2 digit LCD screen, the maximum display value 1999
Multipurpose clamp meter can measure AC / DC voltage and resistance
Low battery indication, overload protection
Diode and continuity measurement function
High resolution of 1mA minimum force
Miniaturization easier to carry
Data retention easier reading

Main Features
DC voltage: 600V
AC voltage: 600V
AC current range: 20A / 200A / 600A
Resistance range: 2kΩ / 20kΩ / 2MΩ
1/2 digital LCD screen, maximum display value 1999
Can measure AC/DC voltage and resistance, etc.
Low voltage indication, overload protection
No diode on-off beep function
High resolution of 10mA minimum
Miniaturized and easier to carry
Data retention is easier to read
Firewire test function
Powered by 2 x AAA 1.5V battery ( not included )

 

Clamp mete

A digital clamp meter

A multimeter with built-in clamp.

A clamp meter measures the vector sum of the currents flowing in all the conductors passing through the probe, which depends on the phase relationship of the currents.

A relatively recent development is a multi-conductor clamp meter with several sensor coils around the jaws of the clamp. This could be clamped around standard two- or three-conductor single-phase cables to provide a readout of the current flowing through the load, with no need to separate the conductors.

The reading produced by a conductor carrying a very low current can be increased by winding the conductor around the clamp several times; the meter reading divided by the number of turns is the current, with some loss of accuracy due to inductive effects.

Clamp meters are used by electricians, sometimes with the clamp incorporated into a general purpose multimeter.

It is simple to measure very high currents (hundreds of amperes) with the appropriate current transformer. Accurate measurement of low currents (a few milliamperes) with a current transformer clamp is more difficult.

Columbia iron vane type clamp-on ammeter, with heads for different ranges

Less-expensive clamp meters use a rectifier circuit which actually reads mean current, but is calibrated to display the RMS current corresponding to the measured mean, giving a correct RMS reading only if the current is a sine wave. For other waveforms readings will be incorrect; when these simpler meters are used with non-sinusoidal loads such as the ballasts used with fluorescent lamps or high-intensity discharge lamps or most modern computer and electronic equipment, readings can be quite inaccurate.

Typical hand-held Hall effect units can read currents as low as 200 mA, and units that can read down to 1 mA are available.

This type of ammeter can measure both AC and DC currents and provides a true RMS current measurement of non-sinusoidal or distorted AC waveforms.Several jaw sizes are available for clamping around large conductors and bus bars up to 4 12 inches (110 mm) wide.As the illustration shows, the scale is very non-linear and unsuitable for measuring low currents, with currents of less than half the full-scale deflection crammed into a short section of the dial.

 

Customer reviews
  • 0
    0 ratings
  • 5 Stars
    0%
    4 Stars
    0%
    3 Stars
    0%
    2 Stars
    0%
    1 Star
    0%
Reviews

There are no reviews yet.

Write a customer review

Be the first to review “DT3266L Clamp meter Digital AC DC Voltage”